How To Wire An Outlet With Red Black And White Wires

White wires augmented with red or black tape or markings are used as hot.

How to wire an outlet with red black and white wires. One of the hot wires attaches to a brass terminal on one side of the outlet and the other attaches to a brass terminal on the other side. Add the pigtail to the 3 wires on the wire nut. Put the black and red wires into the hot ports on the back of the outlet. Place the end of the black wire in the port next to one of the unlabeled screws and the red wire in the port on the other.

Strip about 3 4 inch of insulation from each wire. Attach the black wire to the outlet you want to always be on usually the top one and the red wire to the switched outlet. Remember black and red wires are always hot meaning they are source wires that carry power from the electric service panel to a destination such as an outlet or a light. Step 3 connect the black wire to a brass screw or terminal on the plug and the red wire to the other brass screw.

However a black wire can never be used as a neutral or ground wire or for any purpose other than. When measured with respect to the white neutral wire the red wire carries the same 120 volt current that the black one carries making the voltage across these two hot wires 240 volts. Connect the white wire to either of the chrome screws remember they are still joined and the ground wire to the green ground screw. You can now screw the outlet to the box and proceed to the switch box.

First for god s sake mark the white wire with colored tape so the next guy knows it s a switch loop. Peel one and 1 2 to 2 inches of sheathing from the electrical cable with a wire stripper or sharp knife to expose the wires. Place the ceiling fan motor on the floor and position the canopy on top of the motor feeding the. There will be 2 unlabeled screws left on the back of the outlet which are known as the hot screws.

If you only have black wires in your box connect both the non white wires from the fan to the black wires in the box. Never connect a hot red or black wire to ground nor to the white neutral wire doing so would form a dead short should trip a breaker or if not could cause a fire or could cause a dangerous shock. If there is a hot wire that is not used in a junction box sop would be to cap it off with a twist on connector. The black wire goes to the bundle of black wires.

Figuring out the intent of whoever originally wired the room can be a little bit difficult but it s doable. The white wires on the fan go to the bundle of white wires. Feed the black white red and copper wires through the hole in the center of the mounting plate. It is tied together with a wire going to the switch and the black wire going to the outlet.

Now get a short length 9 of black wire if in doubt use 12 size. This is called a pigtail.